0-26
INITIAL SETUP
Check and fill (if needed) engine with 4-stroke
motor oil that meets or exceeds the requirements for
API service classification SF or SG. Always check
the API SERVICE label on the oil container to be
sure it includes the letters SF or SG. SAE 10w-30
is recommended for general, all-temperature use.
Other viscosities shown in the Honda Owner’s
Manual may be used when the average temperature
in your area is within the indicated range.
•
Be sure the go kart is in a level position.
•
Remove the oil filler cap/
dipstick and wipe it clean.
•
Insert the filler cap/dipstick into the oil
filler neck, but do not screw in.
•
Remove the cap/dipstick and
read the indicated oil level.
•
If the level is low, fill to the top of the oil
filler neck with the recommended oil.
•
Reinstall the oil filler cap/dipstick.
GEAR REDUCTION CASE WITH
AUTOMATIC CENTRIFIGAL CLUTCH.
•
Remove the oil filler cap and
wipe the dipstick clean.
•
Insert the dipstick into the filler
neck, but do not screw in.
•
Remove the cap/dipstick and read
the indicated oil level.
•
If the level is low, fill to the upper level mark
with the same oil recommended for the engine.
•
Do not overfill; see diagram.
<WARNING>
Gasoline is extremely flammable and is explosive under certain conditions. Refuel in a well-ventilated area with the engine
stopped. Do not smoke or allow flames or sparks in the area where the engine is refueled, or where gasoline is stored.
Do not overfill the fuel tank (there should be no fuel in filler neck). After refueling, make sure the tank cap is closed
properly and securely. Be careful not to spill fuel when refueling; spilled fuel or fuel vapor may ignite. If any fuel is spilled,
make sure the area is dry before starting the engine. Avoid repeated or prolonged contact with skin, or the breathing of
vapor.
KEEP OUT OF REACH OF THE PUBLIC.
-20
-0
20
40
60
80
100°F
Ambient temperature
SAE viscosity grades
5w-30
10w-30
30
Cl
utch oi
l f
ill
Engi
ne
oi
l f
ill
Fill notch
Oil drain plug
Oil filler cap
1/2 reduction
Oil level
