IVT JST-12L, Instruction Manual

Page: 14 / 108

14
Manual instruction
EN
12 Volt DC adaptor fuse replacement
• If an overload of the Power Station occurs,
replace the cigarette lighter plug fuse (10A).
• Determine the cause of the problem and how to
solve it before attempting to use the unit again.
fig.5
CAUTION: NEVER REPLACE A BAD FUSE
WITH A FUSE THAT HAS AN AMPERAGE
RATING HIGHER THAN THE ORIGINAL
FUSE.
RECHARGE ONCE A MONTH TO KEEP THE UNIT IN
TOP OPERATION CONDITION.
Recharging procedures
Charging from 120/230 Volt AC outlet
• With the power switch in the OFF position, plug
the AC adapter into a 120/230 AC outlet. Then
insert the plug at the end of the adapter into the
front of the Power Station unit.
• The charging indicator light will light, indicating
that the battery is charging.
fig.6
• When the power switch is turned to the test
position, the top green light should light up when
fully charged, (see battery condition lights below).
DC charging (with cigarette adaptor)
• Make sure the power switch is OFF, and the
vehicle is running.
• Insert one end of the fused cigarette adaptor
into your cars lighter socket and plug the other end
into the Power Station front 12 volt DC input socket.
• The charging indicator light will light indicating
that the battery is charging. You can now recharge
your unit.
• When the power switch is switched to the test
position, the top green light should light up when
fully charged (see battery condition lights below).
NOTE: Do not drive while the Power Station is
charging.
fig.7
Battery condition lights
Top green light – Full Charge
Green light - Good Charge
Yellow light - Weak/Recharge
Red light – Recharge
fig.8
Maintenance and storage
Before any work on the machine itself,
pull the mains plug.
• Always keep the tool and the ventilation
slots (if present) cleaned. Regular cleaning and
maintenance of the appliance will ensure efficiency