IVT JST-12L, Instruction Manual

Page: 13 / 108

13
Manual instruction
EN
gases.
fig.2
• Do not allow the RED (POS+) clamp to touch the
BLACK (NEG-) clamp.
• Now you can start your engine. As soon as your
car is started, disconnect the cables from your car in
the reverse order.
• If your battery is so “dead” that your ignition
light does not come to let the Power Station stay
connected to your battery for 10-20 minutes prior
to attempting to start your car.
Used as a power converter
To use the Power Station as a power converter,
connect the booster cable outputs to the positive
and negative terminals of your car battery. The
power from this battery is then transferred to the
Power Station outputs. Thus you can use the power
from this external battery rather than from your
Power Station.
fig.3
NOTE: Use only 12V appliances that have a cigarette
lighter plug.
Used as a power supply for 3 12V DC appliances
fig.4
You can use three 12V outlets at the same time.
Connect your appliances to the outputs.
NOTE: Do not attempt to jump-start your car when
12 volt DC outlets are in use.
Used as an Air Compressor
CAUTION: DO NOT OVERINFLATE!
Follow the manufacturers
recommendations. This air compressor
is designed for light duty. Please allow the air
compressor to cool if operating for more than 10
continuous minutes. This air compressor and any
other electrical device should be kept away from
all children.
WARNING: when using electrical tools,
basic safety precautions should always
be followed to reduce the risk of fire,
electric shock and personal injury.
• Make sure you have read the item’s manufacturer
inflation recommendations prior to inflate.
• Remove the air hose which is located in the
compartment on the back of the unit. Connect the
air hose to the item to be inflated and included
adapters if needed.
• Move the handle in the air hose down to lock the
adapter in place.
• Turn on the air compressor unit using the switch
located on the front of the unit.
• Hold the air hose in place and monitor the air
pressure gauge on the air compressor unit for the
desired air pressure, once the desired air pressure is
achieved, turn off the air compressor unit using the
switch located on the front of the unit.
• Disconnect the air hose from the item that has
been inflated.
• Store the Power Station in a safe place.
Trouble light
The built-in trouble light in turned on by the switch
on the front of the unit.
Main unit fuse replacement
This unit requires the use of a 15 amp automotive
fuse. To check the fuse: remove the fuse from the
front of the unit. Check the filament , if it is open,
replace it with the spare fuse provided with your
unit. Press the fuse into the fuse holder until it is
tight.