nano3G AP Installation Manual
Installation Overview and Requirements
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012
Page 16
2.4
nano3G E8 AP and nano3G E16 AP Site Requirements
In addition to the site requirements for all APs, each E8 AP and E16 AP will require:
• A site for wall mounting
• Power supplied in one of the following ways:
• From the supplied POE injector, which requires a suitable mains power
supply point near the injector
or
• From a mains adaptor unit, supplied separately, which requires a suitable
mains power supply point near the AP that is within reach of the adaptor’s
cabling
2.4.1
nano3G E8 AP and E16 AP Power Requirements
Maximum expected power consumption:
• 20 Watts (Rated +12V on the DC input or -48V DC on the POE+ input)
The nano3G E8 AP and E16 AP support the following power options:
• Power over Ethernet from a IEEE 802.3at compliant POE+ power source
equipment - a suitable POE+ inserter is supplied with the AP
• Direct power from a suitable DC source (+12V, 2.5A rated centre positive 2.1mm
jack) - a suitable mains adaptor is available separately
These power options are mutually exclusive. When POE+ is used, a DC power adapter
must not be plugged in to the AP and vice versa.
The nano3G E8 AP and E16 AP can be used with any IEEE 802.3at compliant POE+ power
source.
Note:
The Ethernet cable carrying POE+ must be plugged into the LAN 1 port. The LAN 2 port,
next to LAN 1, is not used and does not support POE.
