nano3G AP Installation Manual
Finalize Installation
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012
Page 67
6)
Only if a suitable macro neighbour has been detected, a correction can be applied
to ensure that the oscillator frequency is correct. Select
Actions
and then select
Apply Frequency Correction
.
Note:
Assuming there is a suitable macro neighbour, this should be repeated
approximately 24 hours after the AP is brought into service. This will allow
time for the oscillator crystal to stabilize, at which time the frequency
correction should be re-applied.
7.3
Bring the AP into Service
Once the AP has the latest software image, any additional configuration is complete and
any frequency correction has been applied, it is ready for service.
In most cases, a correctly pre-provisioned AP will start providing service once it has
obtained its configuration from the NOS Server. These steps are only necessary when an
AP is not yet enabled for service, or has been locked to apply additional configuration. An
AP that is administratively Locked will have a small padlock symbol next to the AP icon.
1)
To bring the AP into service, right-click the 3G AP object in the NOS Client and
select
Unlock
. The padlock symbol next to the 3G AP icon will be removed.
2)
If the installation engineer is still on site, the engineer should make CS and PS test
calls to verify the AP is providing service.
