nano3G AP Installation Manual
nano3G AP Hardware Installation
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012
Page 59
POE+ Switch
In this case, the POE+ switch is a third-party item. The cable run from the switch to the AP
can be a full 100m.
A POE+ switch will typically only be used if there are multiple APs on site and/or there is
other equipment that can take advantage of POE+.
PSU and LAN
When a suitable PSU is used to power the AP (see section 2.4.1) the POE+ injector unit is
not needed. However, this means that a mains socket providing power to the AP must be
within reach of the cabling included with the PSU. This is typically less than 2m. The PSU
for the E8 AP or E16 AP is an optional extra.
POE+
Switch
POE+
(max 100m)
Mains Input
LAN
cable
Backhaul
Network to AC
E8/E16
AP
E8/E16
AP
LAN Cable to
nearest switch/gateway
(max 100m)
Mains
Input
12V DC
cable to AP
Backhaul
Network to AC
