nano3G AP Installation Manual
Commission a nano3G AP
N3G_INST_300 v14.0 for N3G_2.85 © ip.access Limited 2012
Page 46
5.5.2
Configure the NOS Server Connection
27)
If a secure connection is required, select
IPSec Enabled
. Also enter the address
for the
IPSec Gateway
and the
Traffic Selector
address and subnet mask.
28)
Enter addresses for the NOS Server (Management Server URL), a suitable CRL
server and the NTP server.
The settings applied on this page are retained permanently as the
default set
of
these parameters, and can only be subsequently changed on this web page from a
commissioning terminal.
Note:
The NTP and CRL servers must be accessible to the AP on start up,
before it has established an IPsec tunnel to the Security Gateway.
29)
To save the configuration, click
Apply Changes
.
Note:
At this point it may be useful to make a separate note of the parameter
values entered in this screen. Alternatively, save a screenshot of the web
page (information about how to take a screenshot is outside the scope of
this manual).
5.5.3
Complete the AP Commissioning
30)
Click the
Connection Config
link on the left, to ensure the correct page is
showing.
31)
To start the AP in normal operation mode, click
Complete Commissioning
.
32)
Acknowledge the warning about changes in the IP configuration and click
OK
.
33)
When the initial configuration is complete, power off the AP and disconnect it from
the commissioning terminal.