Invacare Storm 4 Series, Service Manual

Page: 80 / 102

Invacare® Storm⁴ Series
Removing Headlight
1. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre
Shroud, page 55 .
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
Fig. 6-90
5. Loosen screw A to remove washer B and headlight
from holder.
6. Replace headlight.
Fig. 6-91
Installing Headlights
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.
6.11.6 Replacing Headlight Holder (Conventional)
• Size 2 Phillips screwdriver
• 8 mm wrench
• Oblique pliers
• Tie wraps
80 1533060-N