Invacare Storm 4 Series, Service Manual

Page: 86 / 102

Invacare® Storm⁴ Series
Removing Rear Light Holder
1. Remove rear light as described in 6.11.11 Replacing
Rear Light (Conventional), page 85 .
2. Loosen and remove both Allen screws (1).
3. Replace rear light holder (2).
Fig. 6-108
Installing Rear Light Holder
1. Install parts in reverse order.
2. Test all functions.
6.11.13 Replacing Complete Rear Light (LED)
For the LED lighting unit the rear light shroud is the equivalent of a holder. To replace the rear light shroud, see
6.8.5 Replacing Rear Light Shroud, page 57 .
• 4 mm Allen key
• 13 mm socket wrench
• Oblique pliers
• Tie wraps
Removing Rear Light
1. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre Shroud,
page 55 .
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
Fig. 6-109
5. Loosen nut (1).
6. Lift off rear light shroud (2) carefully.
Fig. 6-110
7. Open rear light plug (3) that is to be replaced.
8. The rear lights are only clamped in plastic casing.
Replace red rear light (1) or indicator (2) as required.
Cables are marked correspondingly.
Fig. 6-111
86 1533060-N