Removing Tyre and Rim on Mobility Device with Pneumatic Tyres
CAUTION!
Risk of explosion
If mobility device is fitted with pneumatic tyres, wheel can explode if air is not released from tyre before
removing wheel.
– Always release air from wheel before you remove it. Depress small tappet in center of valve.
1.
Loosen and remove valve cap.
2.
Depressurise tyre by pressing pin in valve (1).
3.
Loosen and remove 5 screws (2).
4.
Remove wheel rim half with inner tube.
Fig. 6-14
Removing Tyre and Rim on Mobility Device with Puncture-Proof Tyres
WARNING!
Risk of damage to motor if screws are not loosened and removed in correct sequence
– Make sure you loosen and remove screws in correct sequence.
Screws 1 to 5 must be loosened and removed in particular sequence in relation to each other. There is no
pre-defined numbering for screws. There is, for example, no screw with pre-defined number "1". For this reason,
you can start with any screw as "Number 1". "Number 2" is then screw next to it in clockwise direction, "3"
is next and so on.
1.
Loosen and remove screws 1 and 3.
2.
Loosen screws 2, 4 and 5 a single turn each, one
after other, going from screw to screw in a clockwise
direction, until they have all been completely loosened
and removed.
3.
Remove rim-half and puncture-proof inlay from wheel.
Fig. 6-15
Removing Motor
1.
Remove batteries as described in
and
Risk of crushing
True Track Plus motor unit is extremely heavy. Risk of
injury to hands.
– When disassembling, note that True Track Plus motor
is extremely heavy.
CAUTION!
Risk of crushing
True Track Plus motor unit is extremely
heavy. Risk of injury to hands.
– When disassembling, note that True Track
Plus motor is extremely heavy.
1.
Loosen and remove four screws (1) of motor.
Fig. 6-16
1533060-N
33
Summary of Contents for Storm 4 Series
