Invacare Storm 4 Series, Service Manual

Page: 57 / 102

Service
6.8.5 Replacing Rear Light Shroud
• 4 mm Allen key
• 13 mm socket wrench
Removing Rear Light Shroud
1. Remove rear and centre shroud. See 6.8 Shrouds, page
55 .
2. Loosen nut (1) using a 13 mm socket wrench.
Fig. 6-48
Installing Rear Light Shroud
1. Install parts in reverse order.
2. Tighten screws finger-tight.
6.8.6 Replacing Front Fender
CAUTION!
Risk of Crushing to Hands and Feet by Weight of Mobility Device
– Pay attention to hand and feet.
– Use proper lifting techniques.
CAUTION!
Risk of Uncontrolled Movement of Mobility Device
– Turn off power supply (ON/OFF key).
– Engage drive.
– Before raising mobility device, secure wheels by blocking them with wedges.
– Prevent the mobility device tipping by propping it up on a wooden block which is long and wide enough under
the battery case. If the wooden block is too short or too high, the mobility device can still tip.
• 4 mm Allen key
• 24 mm wrench
• Flat screwdriver
• Oblong wooden blocks (at least 14 x 14 x 30 cm)
• Medium-strength thread locking adhesive (Loctite 243 or similar)
• Heat gun
Removing Fender
1. Lift mobility device on one side and place wooden block underneath it, so that castor wheel is off ground and can
rotate freely. Use proper lifting techniques.
2. Remove castor wheel. See 6.7.9 Replacing Castor Wheels on Single-Sided Fork, page 54 .
3.
Fig. 6-49
Loosen and remove the four screws (2) together with washers.
4. Replace fender (1).
Installing Fender
1. Install parts in reverse order.
2. Test all functions.
1533060-N 57