Invacare Storm 4 Series, Service Manual

Page: 77 / 102

Service
Removing Headlight
1. Remove rear and center shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre
Shroud, page 55 .
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
Fig. 6-83
5. Loosen both nuts (1) and remove headlight with holder
from rubber mounting.
6. Loosen both screws (2) to remove headlight from
holder.
7. Replace headlight.
Fig. 6-84
Installing Headlight
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.
6.11.3 Replacing Headlight (Conventional on Modulite)
• Size 2 Phillips screwdriver
• 6 mm Allen key
• Oblique pliers
• Tie wraps
Removing Headlight
1. Remove rear and center shroud. See 6.8.2 Replacing
Centre Shroud, page 55 and 6.8.1 Replacing Rear
Shroud, page 55 .
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
Fig. 6-85
1533060-N 77