Intergraph TDZ-400 Deskside, Setup And Maintenance Manual

Page: 37 / 136

Chapter 2 - Configuring the System 23
♦
A selected resolution, depth, or refresh rate is not supported by the
multi-sync monitor. Try different settings in Video Configuration.
♦
The Dual Screen option is selected in Video Configuration, but only one
video board is detected. Clear the Dual Screen option.
Restart the system and select
Windows NT Workstation 3.51
to use the
reconfigured video display driver. If problems persist, contact the Intergraph
Customer Response Center for help.
Configuring TCP/IP Networking
Configure the TCP/IP networking software using the networking information
you recorded at the beginning of this chapter.
➤
To configure the TCP/IP networking software:
1. Open Network in the Windows NT Control Panel. The Network
Settings dialog displays.
2. Select Change next to the Computer Name field. The Computer Name
dialog displays.
3. Type a name for the computer and select OK.
4. If appropriate, select Change next to the Workgroup field. The
Domain/Workgroup Settings dialog displays.
5. Type a new workgroup name and select OK.
6. Select TCP/IP Protocol from the Installed Network Software list, and
then select Configure. The TCP/IP Configuration dialog displays.
7. Type your system’s Internet Protocol (IP) address and IP subnet mask,
and the IP address of your network’s default gateway.
8. If your network uses the Domain Name System (DNS), select DNS.
The DNS Configuration dialog displays.
9. Type your network’s IP domain name and the addresses of your
network’s DNS servers, and then select OK.
10. In the TCP/IP Configuration dialog, select OK.