IfU TECOTHERM NEO TN300 EN - 01.doc
Page 48 of 76
Ref No. TN300 EN-01
It is not necessary to export and store new current data. All data are stored by the
TECOTHERM NEO on a memory card with large capacity.
After successful export push key T1 Confirm to enter Main MENU.
For stopping operation see following Section 8.4.
8.4. Stop operation/ Turn off device
To stop or to interrupt operation turn back to the TECOTHERM NEO Main MENU.
Then you should follow the MENU instructions looking for entry Power Off: Push arrow
key
▼
to move to entry POWER OFF.
TECOTHERM NEO Main Menu
Ser.-Nr. 2010/08/01
Rev. 023/01.32
Highlight and Select Function Required:
Servo controlled complete treatment mode
Servo control mode (constant rectal temperature)
Constant Mattress Temperature Mode
Alarm check
Export treatment data
Service
Power Off
Select
Language
After few seconds device is shut off.
NOTE
Push button (1) is lit as long as system is plugged to mains. Unplugging
mains cause green push button light to turn off.
NOTE
Finally TECOTHERM NEO system should be put into and left in a state to guarantee
properly starting a new hypothermia treatment.