![Ingersoll-Rand 070008 Maintenance Manual Download Page 70](http://html.mh-extra.com/html/ingersoll-rand/070008/070008_maintenance-manual_2060247070.webp)
Operating Instructions
69
Time
The Time and Date held by the HMI Control
Panel can be checked. Time and Date cannot be
changed from the Main Menu. The time and date
is accessed using the Main Menu. From the
Standard Display, press the MENU Key (Figure
148).
Figure 148: Menu Key
The Main Menu will appear. Press the UP or
DOWN Key as required to choose the Time
Menu. When the Time Menu is selected, press the
SELECT Key to choose the Time Menu (Figure
149).
Figure 149: Select Key
The date and time held in the HMI Control Panel
will be shown on the display (Figure 150). Time
and Date cannot be changed from the Main Menu.
Figure 150: Date and Time
To return to the Main Menu press the EXIT Key.
To return to the Standard display press the EXIT
Key again.
Clear All ECU Faults
NOTE: On C-600 units this menu selection is
only displayed on early versions of HMI software
and is not functional. It is not displayed on
C-600 units with later versions of HMI software.
Manual Pretrip Inspection
(Before Starting Unit)
The following Manual Pretrip Inspection should
be completed before starting the unit and loading
the trailer. While the pretrip inspection is not a
substitute for regularly scheduled maintenance
inspections, it is an important part of the
preventive maintenance program designed to head
off operating problems and breakdowns before
they happen.
Fuel:
The diesel fuel supply must be adequate to
guarantee engine operation to the next check
point.
Engine Oil:
The engine oil level should be at the
FULL mark with the dipstick turned (threaded)
into oil pan. Never overfill.
Coolant:
The engine coolant must have antifreeze
protection to -30 F (-34 C). Alarm Code 37
indicates low coolant. Add coolant in the
expansion tank
Battery:
The terminals must be clean and tight.
Belts:
The belts must be in good condition and
adjusted to the proper tensions.
Electrical:
The electrical connections should be
securely fastened. The wires and terminals should
be free of corrosion, cracks or moisture.
MENU
35
°F
35
SET
SENSORS
GAUGES
POINT
.8
ON
OFF
MAIN MENU
DOWN
EXIT
SELECT
UP
ELECTRIC STANDBY
ADJUST BRIGHTNESS
TIME
CLEAR ALL ECU FAULTS
ON
OFF
ON
OFF
TIME MENU
01:18 MONDAY 10 DEC 2012
EXIT
CAUTION: Do not remove expansion
tank cap while coolant is hot.
CAUTION: Do not add “GREEN” or
“BLUE-GREEN” conventional coolant to
cooling systems using “RED” Extended
Life Coolant, except in an emergency. If
conventional coolant is added to Extended
Life Coolant, the coolant must be changed
after 2 years instead of 5 years.