Operating Instructions
36
•
RETRIEVE
•
Retrieve OptiSet Plus files
The Flash Drive is also available from the Main
Menu.
The Flash Drive Menu will time out about 30
seconds after the engine starts. When the Flash
Drive Menu times out, the Standard Display will
appear. To go to the Standard Display
immediately press the EXIT Key.
Configurable Soft Keys
When the Standard Display is shown, the default
functions of the two center soft keys are
GAUGES and SENSORS (Figure 21).
Figure 21: Soft Keys
The functions of these two keys can be changed as
required for customer convenience. The functions
of these two soft keys on the Standard Display can
be re-assigned to any of the following functions
using the Guarded Access > Main Menu
Configuration menu:
The GAUGES and SENSORS functions are
always available from the Maintenance Menu.
In the example shown in Figure 22, the soft key
functions from the Standard Display have been
changed to PRETRIP and SOT (Start of Trip
marker). The GAUGES and SENSORS functions
are always available from the Maintenance Menu.
Figure 22: PRETRIP and SOT
Display Heater
The HMI Control Panel is equipped with a display
heater. This heater is needed to make the display
visible in very cold ambient temperatures.
The HMI has its own internal temperature sensor
for the display heater. The heater is energized
when the unit is turned on and the ambient
temperature is below 29.4°F (-2°C). The heater
turns off when the temperature sensed by the
internal sensor rises above 37.4°F (+3°C). The
heater draws from 1.4 to 1.7 amps when
energized.
The colder the ambient temperature the longer it
will take for the heater to make the display visible
on a cold startup. It may take 10-15 seconds for
the display to appear with extremely cold
temperatures.
If a Language is Enabled
If more than one language has been enabled from
the Guarded Access Language Menu, a prompt
will appear to allow the desired language to be
chosen as shown below. Only languages
specifically enabled from the Guarded Access
Menu are available. If a different language is
desired, press the NO Key (Figure 23).
IMPORTANT: The engine start is not delayed by
the language prompt shown below. The prompt
will appear for 10 seconds and then the engine
will start. After the engine is started the display
will return to the prompt shown.
Figure 23: NO Key
• Gauges
• Pretrip
• SOT (start of trip)
• Sensors
• Data Logger
• Hourmeters
ON
OFF
MENU
35
°F
35
SET
SENSORS
GAUGES
POINT
.8
ON
OFF
MENU
35
°F
35
SET
SOT
PRETRIP
POINT
.8
ON
OFF
YES
NO
CURRENT LANGUAGE IS
ENGLISH
OK?
