Installation / Assembly
T-Rack
®
3.0 Series
– Assembly Instructions 1.1(2019-03) E inge
Page 51 of 84
© inge GmbH
Step
Activity
Figure
2
Connect the lower T pieces of modules 1 and 2
Number of persons: 2
a)
Continue holding modules 1 and 2 in position to prevent
tipping.
b)
At the connection of module 1, pull the gasket over the
connection of module 2 so that it is centered between the
grooves of both connections.
c)
Place a flexible coupling 6” half-shell around the gasket.
Ensure that the contact surfaces of the coupling half-shells
are resting in the provided grooves.
d)
Place the second flexible coupling 6” half-shell on the first
and insert the bolts in the openings.
cut-trough section showing
the gap between two T-
pieces after mounting the
composite coupling
e)
Tighten the flexib
le coupling 6” with two nuts M12 and
washers using an open-end or box wrench (size 19) until
the contact surfaces of both coupling halves are flush and
resting against each other without a gap.
Ensure that the nuts are tightened evenly and alternately.
Ensure that the square screw neck of each screw is
correctly positioned in each threaded hole.
f)
Continue holding the two attached modules 1 and 2 in
position to prevent tipping.
