Installation / Assembly
T-Rack
®
3.0 Series
– Assembly Instructions 1.1(2019-03) E inge
Page 66 of 84
© inge GmbH
Step
Activity
Figure
3
Attach the connectors
a)
Position the connector on the corresponding pipe end.
Pull the gasket from the pipe over the connector so that the
gasket is centered on the connection surfaces of the pipe
and connector.
b)
Place a flexible coupling 6” half-shell around the gasket.
Ensure that the contact surfaces of the coupling half-shells
are resting in the provided grooves.
c)
Place the second flexible coupling 6” half-shell on the first
and insert the two bolts in the openings.
d)
Tighten the flexible
coupling 6” with two nuts M12 and
washers using an open-end or box wrench (size 19) until
the contact surfaces of both coupling halves are flush and
resting against each other without a gap.
Ensure that the nuts are tightened evenly and alternately.
Ensure that the square screw neck of each screw is
correctly positioned in each threaded hole.
