Imagine Selenio X100, Installation And Operation Manual

Page: 45 / 178

Selenio X100
Installation and Operation Manual
33
Profanity delay requires the installation of one X100OPT-SK-PD software key.
Figure 3-3 Profanity (Program Delay)
Follow these steps to use the feature:
1 At Video Input Control and Status > Input Routing , feed the program content into the
primary channel ( Proc Ch 1 Source ).
Feed the backup or “bail-out” source to the secondary channel ( Proc Ch 2 Source ).
Or
Convert a trouble slide to a logo ( see Logo Generation and Insertion on page 56 for
details) and then upload the logo to the X100, enabling it in the second channel as an
alternate bail-out source.
2 Set the desired profanity delay value using Video Output and Routing > Program Delay
> Delay Channel 1 .
3 Once you have set the profanity delay value, the following three options are available:

Processing Channel 1 (delayed program content is routed to the master control
switcher, for example)

Processing Channel 2 (backup, bailout or trouble slide)

Processing Channel 1 Und On-Screen Display (to the master control operator's
picture monitor, for example)
Note: In profanity delay mode, on-screen display is only available on the non-delayed
channel.
To switch the delayed program content over to the backup (or bail-out) source or trouble
slide, toggle
Video Output and Routing > Program Delay > Profanity Bail Out to Yes.
This action switches all physical video outputs that are connected to Processing Channel 1
(the delayed program content) to Processing Channel 2 (the backup, bailout or trouble
slide).
Individual Channel Delay Mode (Dual Channel Mode)
To configure the X100 to operate in individual channel delay mode, set the Operation
Mode to Dual Channel . Depending on whether you have one or two X100OPT-SK-PD
software keys, the Delay Channel control slide bar is then enabled for each channel. The
resolution for the channel delay is displayed in frames; the maximum duration is dependent
on the configuration shown in
the Selenio X100 Delays Table .
Master Control
Operator’s
Picture Monitor
Master Control
Switcher
OPTIONAL MEMORY
(20s)
SDI
AES
DATA
Clean
2 x1
Switcher
Profanity (Program) Delay
Program Content
Backup, Bail-Out, Trouble Slide
Undelayed Program Content
Delayed Program Content Delayed Program Content