Selenio X100
Installation
24
The frame automatically detects the cable type and assigns an IP address to the computer
so that they are on the same subnet. You can also set the IP address on the frame itself if
the frame has a front control panel.
2
Launch a browser and type anything in the address bar.
The Selenio X100 control interface appears.
3
Select
Configuration
and ensure that the Frame Controller is selected in the tree view at
the left of the screen.
4
On the Frame Control Panel, select
General
.
5
On the
Basic
screen, enter an IP address for the frame.
The IP address should be consistent with your network’s configuration. For more
information, contact your network administrator.
6
Connect the Selenio X100 to a hub on your network.
7
Follow the instructions in
Logging In To the Selenio X100 Control Interface
Logging In To the Selenio X100 Control Interface
To open a browser connection to an Selenio X100, follow these steps:
1
In your browser, enter the IP address of the Selenio X100, and then click
Enter
to connect.
If the Selenio X100 is in a failed state (i.e., disconnected), then you will see a “browser
cannot display the page” or “browser could not connect” message.
2
Enter a defined user name and password.
The default user name is Administrator, and by default there is no password (leave the field
blank).
3
Click
Enter
.
The
Selenio X100
control interface appears.
The number of PCs connected to the Selenio X100 has an impact on receiving data in a
timely fashion. If a large number of users are logged into the frame, response time may
become slower. Up to ten separate PCs can be connected to the Selenio X100 at any one
time. If additional users attempt to connect to the Selenio X100, they will receive a
message:
Server Busy. Please try again later.
When you are not actively using the interface, please log off out of the system.
Note:
The IP address is assigned to the frame, not the Controller module. When you
change Controller modules, you should not have to reassign the IP address.
Exiting the Control Interface
To log off the Selenio X100 control interface, do one of the following:
Close your browser.
Navigate to a different page in your browser.
Click
Logout
in the top right corner of the control panel
Summary of Contents for Selenio X100
