IFM CR711S, Original Programming Manual

Page: 150 / 205

150
ifm Programming Manual ecomatController/60-1 (CR711S) Operating System V2.5.0.n 2017-12-19
ifm function libraries Library ifmOutHBridge
>
Diagnostic codes (
→ Messages / diagnostic codes of the function blocks
(
→ p.
180 )):

STAT_PREPARING State: FB/FUN is processed; final results are not yet available. Some output values are
updated in each PLC cycle.

STAT_DONE State: FB/Function has been successfully executed and completed. There are valid
results on the outputs.

ERR_INVALID_VALUE Error: At least one input parameter is invalid or outside the value range.

ERR_INTERNAL Error: Internal system error
► Contact the ifm Service Center!

ERR_UNDEFINED Error: Unknown error
► Contact the ifm Service Center!

ERR_SHORT_CIRCUIT Error: Short circuit with GND or VBBx.

ERR_STUCK_AT Error: Signal is frozen.

ERR_STUCK_AT_HIGH Error: Signal frozen, signal state high.

ERR_STUCK_AT_LOW Error: Signal frozen, signal state low.

ERR_UNDERVOLTAGE_VBBX

For inputs: Error: Reference voltage not reached.

For outputs. Error: The voltage of the corresponding output group supply or at
VBB30 / VBB15 is not reached.

ERR_OVERVOLTAGE_VBBX

For inputs: Error: Reference voltage exceeded.

For outputs. Error: Voltage of the corresponding output groups supply or at VBB30
/ VBB15 not reached.

DIAG_INVALID_VALUE At least one input parameter is invalid or exceeds the permissible area.

DIAG_INTERNAL Internal system error.

DIAG_ACCESS FB/Function cannot access the required resource; Resource is blocked by another task.

DIAG_CHANGEOVER_TIME Minimum changeover time for the highside-lowside selection of the drivers has not yet
expired.

DIAG_UNDERVOLTAGE_VBBX

For inputs: Error: Reference voltage not reached.

For outputs. Error: The voltage of the corresponding output group supply or at
VBB30 / VBB15 is not reached.

DIAG_OVERVOLTAGE_VBBX

For inputs: Error: Reference voltage exceeded.

For outputs. Error: Voltage of the corresponding output groups supply or at VBB30
/ VBB15 not reached.

DIAG_STUCK_AT Error: Signal is frozen.

DIAG_STUCK_AT_HIGH Error: Signal frozen, signal state high.

DIAG_STUCK_AT_LOW Error: Signal frozen, signal state low.

DIAG_SHORT_CIRCUIT Error: Short circuit with GND or VBBx.

DIAG_NO_CALIB The selected resource has no valid calibration.
The displayed values are maybe faulty.

DIAG_CONTROL_DITHER The requested dither value cannot be set because the calculation from dither and PWM
value is higher than 1000 per mill.
>