Hybrid Ultra
855-350-050_Rev2.0_Instruction Manual
Page
77
of 84
5.0
OPERATION: PARALLEL (Not applicable)
6.0
OPERATION: STANDARD POWER SYSTEM
(Not applicable)
7.0
FAQs
7.1
Is the DC Converter’s power in addition to the system
power?
The integrated DC-DC Converter Module draws its power from the Power
Modules. If there are 1400 watts of Power Modules, the DC-DC Converter
Module will take up to 700 watts leaving 700 watts for other load devices.
7.2
How do I access the web-based configuration utility?
•
Check the correct IP address for the system by downloading and
running the ICT IP Address Discovery tool from http://www.ict-
power.com/tools-utilities/.
•
Check the network cable connections to the unit and the network.
•
Ensure the network card settings on the computer are configured
for accessing the IP address of the Hybrid Ultra. To access a unit
with the default IP address of 192.168.0.180 the typical network
settings for the computer are:
o
IP Address: 192.168.0.180
o
Subnet Mask: 255.255.255.0
o
Gateway: 192.168.0.1
•
If the HTTP port of the unit has been changed, append the new port
number to the URL used to access the unit (see Section 4.8.2). See
the Password Reset Section (see Section 4.8.5) for details on how
to reset the port number to the factory default value.
•
If the network switch allows the user to manually configure port
speed and duplex settings, turn-on “Auto Negotiation” for the
switch port that the unit is connected to.
7.3
How do I receive e-mails from the unit?
•
See Section 4.8.3 E-MAIL SETUP.
•
Verify that the "Send E-mail" check boxes are selected for any
alarm conditions for which the user wishes to receive e-mail
notifications.
•
Verify the e-mail settings by going to the
"Communications/Maintenance" tab on the unit’s GUI and clicking