![background image](http://html1.mh-extra.com/html/icom/ic-905/ic-905_advanced-manual_4161563023.webp)
1
ADVANCED OPERATIONS
1-18
Repeater operation
A repeater receives your transceiver’s signals and
simultaneously retransmits them on a different
frequency to provide a greater communication range�
When using a repeater, the transmit frequency shifts
from the receive frequency by an offset amount. You
can access a repeater using the split function�
1� Select the VFO mode�
2� Set the operating mode to “FM�”
3� Set the receive frequency (Repeater output
frequency)�
For only the USA version:
When the Auto Repeater function is turned ON, steps
4 and 5 are not necessary� The Auto Repeater function
automatically sets the repeater settings (duplex ON/
OFF, duplex direction, tone encoder ON/OFF)�
L
You can turn OFF the function and manually set the
repeater settings�
» SET > Function >
Auto Repeater
4� Set the Duplex direction and frequency offset�
• See page 1-20 for setting details�
5� Turn ON the repeater tone, and set the repeater
tone frequency�
• See page 1-19 for setting details�
6� Communicate in a normal way�
• Subaudible tones are superimposed on your transmit
signal�
TIP:
To access a repeater using the DR function, see
Section 10 for details�
D
Checking the repeater input signal
You can check whether or not you can directly receive
another station’s transmit signal, by listening to the
repeater input frequency�
L
While listening, the RX indicator lights green, and then the
Noise Reduction and Notch Filter settings are canceled�
While receiving, hold down
to listen to the
repeater input frequency�
While holding down
�
Receive frequency
is displayed�