![background image](http://html1.mh-extra.com/html/icom/ic-905/ic-905_advanced-manual_4161563008.webp)
1
ADVANCED OPERATIONS
1-3
∂
TX function
The
∂
TX function shifts your transmit frequency up to
±9�99 kHz without shifting the displayed frequency�
1� Push
�
• The
∂
TX function turns ON�
L
If the RIT function turns ON, hold down
for
1 second�
L
While using the Fine Tuning function (Basic manual),
the
∂
TX frequency is displayed in 4 digits, instead of
3�
L
Pushing
again turns OFF the
∂
TX function�
2� Rotate
to set the
∂
TX frequency to match
the received station’s frequency, up to ±9�99 kHz�
L
You can reset the
∂
TX frequency to “0�00” by holding
down
for 1 second�
3� After communicating, push
to turn OFF
the
∂
TX function�
D
∂
TX monitor function
When the
∂
TX function is ON, you can directly
monitor the operating frequency by holding down
�
L
While monitoring, the Noise Reduction, Notch filter, and
Twin PBT are temporarily turned OFF�
Operating CW (ADVANCED)
D
About the CW Reverse mode
The CW-R (CW Reverse) mode reverses the receive
Beat Frequency Oscillator (BFO) to receive CW
signals�
Use this when interfering signals are near the desired
signal, and you want to use the CW-R to reduce
interference�
TIP: Reversing the carrier point
The carrier point of the CW mode is USB by default�
You can change it to LSB in the following menu�
» SET > Function >
CW Normal Side
L
When this setting is set to “LSB,” the CW and CW-R
modes are reversed�
∂
TX frequency
(3 digits)
Set the
∂
TX
frequency�
BFO
BFO
Desired
signal
Desired
signal
Interference
Interference
CW mode (USB side)
CW-R mode (LSB side)