8
D-STAR OPERATION <BASIC>
8-10
D
Using the DR mode scan
The DR mode scan is useful to find a repeater.
To quickly find a repeater, the DR mode scan skips re-
peaters that are not specified as an access repeater.
(The “USE (FROM)” setting is set to “NO” (SKIP is set)
on the repeater list.)
Example:
Select the “Hirano” repeater using the DR
mode scan.
Push
q
DR
(
C
) to select the DR mode.
Push
w
MENU
(
C
) to display the “D-1” screen (D-1
menu).
Touch [SCAN](
e
D
) to start the DR mode scan.
• The frequency decimal point and “FROM” blink while
scanning.
• The repeaters in the repeater list are sequentially dis
-
played.
• The scan pauses when a signal is received. The scan
resumes the same as other scans. (p. 12-5)
When the transceiver receives a signal from a re-
r
peater, the scan stops, then touch [SCAN](
D
).
• The DR mode scan is cancelled.
You can skip certain repeaters as a scan target. You
can also skip all repeaters in certain groups from a
scan. See page 9-42 for details.
NOTE:
Even if the transceiver receives a signal from a re-
peater, the repeater may not receive the transceiv-
er’s signal, because the repeater’s output power is
higher than the transceiver’s.
“FROM” (Access repeater) setting (Continued)
While receiving a signal
from a repeater
While DR mode scanning
Blinks
The repeaters
are sequentially
displayed.
“Hirano” repeater is selected in
“FROM.”
Means “JM1ZLK”
is using the “Hi-
rano” repeater.
Touch [SCAN]
Touch [SCAN]
L
eft
R
ight
C
enter
D
isplay
The DR mode scan also scans simplex frequencies if
they are entered in the repeater list.
While receiving a
signal on 438.030.
Blinks
The
L
,
R
,
C
or
D
in the
instructions indicate the
part of the controller.
L
: Left side
R
: Right side
C
: Center bottom
D
: Display (Touch screen)
Previous view