![background image](http://html.mh-extra.com/html/icom/ic-705/ic-705_advanced-manual_612188069.webp)
9-3
9. OTHER FUNCTIONS
Measuring SWR
D
Plot measurement
You can measure the SWR over the entire set
frequency range.
1. Set the desired frequency band.
2. Set the RF power to more than 5 W.
3. Display the SWR GRAPH screen.
»
SWR
4. Set the center frequency for the SWR to
measure. (Example: 14.080.00)
5. Touch [STEP] several times to set the
measuring step, or touch [BAR] several times
to set the number of graph bars.
Center frequency
Measuring step
Number of
graph bars
L
You can select between 10, 50, 100, and 500
kHz measuring steps.
L
You can select between 3, 5, 7, 9, 11, and 13
graph bars.
6. Touch
to start measuring.
•
Displays the frequency marker “▲” and the
measurement frequency.
NOTE:
Before transmitting, monitor the
operating frequency to make sure you will not
cause interference to other stations on the same
frequency.
7. Hold down [PTT] to transmit.
• The bar graph displays the SWR.
L
When the Break-in function is ON in the CW
mode, you can use a straight key or paddle to
transmit.
Measuring SWR
Measurement
frequency
Frequency marker
8. Release [PTT] to stop transmitting.
L
When using a straight key or paddle, stop
keying.
9. Repeat steps 7 and 8 to measure the SWR
over the entire frequency range.
The center frequency is displayed
after the measurement
The best match is
within this range.
(1.5 or less)
TIP:
• Rotate
to move the frequency marker
“▲” to the current transmit frequency.
• “<<” (low) or “>>” (high) is displayed when the
transmitted frequency is out of the displayed
range.
• Touch [RECALL] for 1 second to move the
frequency marker “▲” back to the center
frequency.
• Touch the bar graph to delete the measured SWR.