![background image](http://html.mh-extra.com/html/icom/ic-705/ic-705_advanced-manual_612188060.webp)
8-4
8. SCANS
Programmed scan and Fine Programmed scan
Repeatedly scans the Program Scan Edge
ranges.
Lower
frequency
Higher
frequency
Scan
Jump
L
To change the upper and lower frequency, see
page 8-5 for details.
L
If the same frequencies are entered into the upper
and lower frequency, the Programmed scan does
not start.
L
The Fine Programmed scan is most effective in
the SSB, CW, and RTTY modes.
D
Programmed scan operation
1. Select the VFO mode.
2. Select the operating mode and tuning step.
(Example: USB, 1 kHz)
3. Display the SCAN screen.
»
SCAN
4. Touch [PROG] for 1 second.
5. Touch the frequency range to scan.
(Example: P00)
Blinks
Blinks
• The Programmed scan starts.
L
When a signal is detected, the scan pauses
according to the “SCAN Resume” setting, and
then resumes.
L
You can change the tuning step by touching kHz.
L
To cancel the scan, touch [PROG].
6. To switch to the Fine Programmed scan,
touch [FINE].
Blinks
• The tuning step changes to 50 Hz steps.
L
When a signal is detected, the tuning step
changes to 10 Hz steps.
L
To return to the Programmed scan, touch [FINE]
again.
7. To close the SCAN screen, push
.