![background image](http://html.mh-extra.com/html/icom/ic-705/ic-705_advanced-manual_612188013.webp)
2-2
2. ADVANCED OPERATIONS
∂
TX function
The
∂
TX function shifts your transmit frequency
up to ±9.99 kHz without shifting the displayed
frequency.
1. Push
.
∂
TX frequency
(3 digits)
• The
∂
TX function turns ON.
L
If the RIT function turns ON, hold down
for 1 second.
L
While using the Fine Tuning function (Basic
Manual), the
∂
TX frequency is displayed in 4
digits, instead of 3.
L
Pushing
again turns OFF the
∂
TX
function.
2. Rotate
to set the
∂
TX frequency to
match the received station’s frequency up to
±9.99 kHz.
Set the
∂
TX
frequency.
L
You can reset the
∂
TX frequency to “0.00” by
holding down
for 1 second.
3. After communicating, push
to turn
OFF the
∂
TX function.
D
∂
TX monitor function
When the
∂
TX function is ON, you can directly
monitor the operating frequency by holding down
.
L
While monitoring, the settings for the Noise
Reduction, Notch filter, and Twin PBT are
temporarily turned OFF.
Operating CW (ADVANCED)
D
About the CW Reverse mode
The CW-R (CW Reverse) mode reverses the
receive Beat Frequency Oscillator (BFO) to
receive CW signals.
Use this when interfering signals are near the
desired signal, and you want to use the CW-R to
reduce interference.
Interference Desired
signal
BFO
BFO
Desired
signal
Interference
TIP: Reversing the carrier point
The carrier point of the CW mode is LSB by
default.
You can change it to USB in the following menu.
» SET > Function >
CW Normal Side
L
When this setting is set to “USB,” the CW and
CW-R modes are reversed.
CW mode (LSB)
CW-R mode (USB)