IBM SAN Volume Controller 2145-CG8, Hardware Maintenance Manual

Page: 70 / 372

DANGER
Multiple power cords. The product might be equipped with multiple power cords. To remove all
hazardous voltages, disconnect all power cords. (L003)
svc00322
1 2
or
1
2
svc00735
or
1
3 4
2
svc00734
The SAN Volume Controller 2145-CG8 or 2145-CF8 uses two toolless cable-retention brackets, one to
retain each cable from the uninterruptible power-supply to one of the two SAN Volume Controller
2145-CG8 or 2145-CF8 power supplies, as shown in Figure 24.
Each cable-retention bracket attaches to the back of the SAN Volume Controller 2145-CG8 or 2145-CF8
node. The brackets connect without screws.
To replace each cable-retention bracket, perform these steps:
1. If you removed the node from the rack, replace the node in the rack, as described in “Replacing the
SAN Volume Controller in a rack” on page 55.
2.
If you removed any Fibre Channel or Ethernet cables, use the labels you placed on each cable to
replace all Fibre Channel and Ethernet cables in the same ports from which they were removed.
3. Loosely install the cable-retention bracket on a power cord by slipping the power cord into the notch
on the rear of the bracket.
4. Align the cable-retention bracket on the power cord so that the bracket is to the left of the cord, as
shown by
2
in Figure 24.
1
2
Figure 24. Cable-retention brackets
40
IBM SAN Volume Controller Hardware Maintenance Guide
|
|
||
|
||
|
||
|
|
|
|
|
|
|