IBM SAN Volume Controller 2145-CG8, Hardware Maintenance Manual

Page: 112 / 372

Important: Before you slide the cover forward, make sure that all the tabs on both the front, rear, and
side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be
very difficult to remove the cover later.
To replace the top cover on the SAN Volume Controller 2145-CG8 or 2145-CF8, complete the following
steps:
1. If you removed the node from the rack, replace the node in the rack, as described in “Replacing the
SAN Volume Controller in a rack” on page 55.
2. Make sure that all cables, adapters, and other components are installed and seated correctly and that
you have not left loose tools or parts inside the node. Make sure that all internal cables are correctly
routed. If you disconnected the Fibre Channel and Ethernet cables, make sure that each cable is
reconnected to the same port from which it was removed.
3. If you removed the power cords, replace the power cords and the cable-retention brackets, as
described in “Replacing the cable-retention bracket” on page 39.
4.
Position the cover on top of the SAN Volume Controller 2145-CG8 or 2145-CF8.
Important: Before you slide the cover forward, make sure that all the tabs on both the front, rear, and
side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will
be very difficult to remove the cover later.
5. Slide the cover toward the front of the node, as shown in Figure 69.
1
Cover
2
Blue locking tab
6. Verify that the cover correctly engages all the inset tabs on the node.
7. Lift the locking levers (
1
in Figure 70 on page 83) on the slide rails and push the server
2
all the
way into the rack until it clicks into place.
1
2
Figure 69. Replacing the SAN Volume Controller 2145-CG8 or 2145-CF8 cover
82
IBM SAN Volume Controller Hardware Maintenance Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|