IBM QS22 - BladeCenter - 0793, Service Manual

Page: 123 / 158

Table 21. BMC firmware messages (continued)
Message Severity Event Automatic Action by
BMC
Action required by
user
Drive bay 1, hard
drive (ModFD Error)
fault
Error A fault has occurred with the
modular flash drive.
Remove and reseat
the modular flash
drive. Reboot.If the
error condition
continues, replace the
modular flash drive
with a similar unit and
reboot.If this does not
correct the problem,
contact IBM service.
Firmware progress events
FW/BIOS, firmware
progress (Pri FW
Corrupt) system
board hang
Error An error has occurred on the
system board during boot.
Blade reboots
If the error persists,
contact IBM service.
FW/BIOS, firmware
progress (Pri FW
Corrupt) no system
memory
Error No system memory was found Blade does not power on Add system memory,
or reseat existing
system memory.
Reboot.
FW/BIOS, firmware
progress (Pri FW
Corrupt) no usable
system memory
Error System memory was found,
but is unusable
Blade does not power on Check supported
memory
configurations. See
“Adding or changing
system memory” on
page 39 for further
information.
Memory subsystem
Memory device x
(DIMM x
uncorrectable ECC
memory
errorwhere x is the
number of the
affected DIMM.
Error A system DIMM or an I/O
buffer DIMM has returned an
uncorrectable error.
The affected memory
channel is disabled. If the
error concerns and I/O
buffer DIMM, both I/O
buffer DIMMs are
disabled.
Replace the affected
DIMM. If the problem
continues, contact
IBM service.
Memory device x
(DIMM x memory
disabledwhere x is
the number of the
affected DIMM.
Error A system DIMM or an I/O
buffer DIMM has returned an
uncorrectable error.
The affected memory
channel is disabled. If the
error concerns and I/O
buffer DIMM, both I/O
buffer DIMMs are
disabled.
Chapter 5. Diagnostics and troubleshooting
105