IBM QS22 - BladeCenter - 0793, Service Manual

Page: 70 / 158

Complete the following steps to install the blade server front bezel assembly:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 29.
2. Connect the control panel cable to the control panel connector on the system
board assembly.
3. Carefully slide the front bezel assembly onto the blade server, as shown in
Figure 24, until it clicks into place.
Note: Make sure that you do not pinch any cables when you reinstall the front
bezel assembly.
Closing the blade server cover
Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Control-Panel
Cable
Bezel release
Bezel assembly
Blade cover
Control-Panel
Connector
Cover release
Cover release
Bezel release
Figure 24. Installing the front bezel assembly
52
BladeCenter QS22 Type 0793: Problem Determination and Service Guide