IBM QS22 - BladeCenter - 0793, Service Manual

Page: 91 / 158

Table 8. BMC test results
Test Number Status
Extended
results Actions
166-801-
xxx
BMC
Abort BMC I2C test
canceled: the
BMC returned
an incorrect
response length.
1. Turn off the system and disconnect it from power. The
system must be removed from AC power in order to reset
the BMC.
2. After 45 seconds, reconnect the system to power and turn
on the system.
3. Run the test again.
4. Make sure that the DSA Diagnostic code is at the latest
level. The latest level DSA Diagnostic code can be found
on the IBM Support Web site at http://www.ibm.com/
support/docview.wss?uid=psg1SERV-DSA/.
5. Check BMC firmware level and upgrade if necessary. The
installed firmware level can be found in the DSA Diagnostic
Event Log within the Firmware/VPD section for this
component. The latest level firmware for this component
can be found on the IBM Support Web site at
http://www.ibm.com/support/us/en/.
6. Run the test again.
7. If the test continues to fail, refer to the other sections of this
chapter for diagnosis and corrective action.
166-802-
xxx
BMC
Abort BMC I2C test
canceled: the
test cannot be
completed for an
unknown reason.
166-803-
xxx
BMC
Abort BMC I2C test
canceled: the
node is busy; try
later.
166-804-
xxx
BMC
Abort BMC I2C test
canceled: invalid
command.
166-805-
xxx
BMC
Abort BMC I2C test
canceled: invalid
command for the
given LUN.
166-806-
xxx
BMC
Abort BMC I2C test
canceled:
timeout while
processing the
command.
166-807-
xxx
BMC
Abort BMC I2C test
canceled: out of
space
166-808-
xxx
BMC
Abort BMC I2C test
canceled:
reservation
canceled or
invalid
reservation ID
166-809-
xxx
BMC
Abort BMC I2C test
canceled:
request data
was truncated.
166-810-
xxx
BMC
Abort BMC I2C test
canceled:
request data
length is invalid.
166-811-
xxx
BMC
Abort BMC I2C test
canceled:
request data
field length limit
is exceeded.
166-812-
xxx
BMC
Abort BMC I2C test
canceled: a
parameter is out
of range.
Chapter 5. Diagnostics and troubleshooting
73