IBM QS22 - BladeCenter - 0793, Service Manual

Page: 100 / 158

Table 12. DIMM boot errors (continued)
Code Message Description Action
E1200 Error during memtest.
This message appears with one of
the following informational
messages:
Memory test failed
Detected MIC SRAM parity error. MIC SRAM parity failed during
memtest.
MIC detected a parity error in an
internal buffer.
Detected MIC Data write error. MIC DERR during memtest
MIC received a DERR condition
from another on chip unit upon a
write request from that unit.
Detected single-bit ECC error
(recoverable) on DIMM x or DIMM
y.
A correctable error occurred
during memtest.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, “Parts listing,” on
page 27* for details of supported
DIMMs.
Detected multi-bit ECC
uncorrectable error on DIMM x or
DIMM y.
An uncorrectable error occurred
during memtest
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, “Parts listing,” on
page 27 for details of supported
DIMMs.
Stuck data bit on DIMM x. Stuck data bit during memtest.
One or more data lanes failed in
the stuck bit test.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, “Parts listing,” on
page 27 for details of supported
DIMMs.
Stuck address bit on DIMM x. Stuck address bit during memtest.
One or more address lanes failed
in the stuck bit test.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, “Parts listing,” on
page 27 for details of supported
DIMMs.
E1300 No memory available at address
zero. Aborting system boot.
No memory is assigned to
address 0. Due to error E1100 all
memory attached to CPU with
address zero must be disabled.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, “Parts listing,” on
page 27 for details of supported
DIMMs.
82
BladeCenter QS22 Type 0793: Problem Determination and Service Guide