IBM QS22 - BladeCenter - 0793, Service Manual

Page: 124 / 158

Table 21. BMC firmware messages (continued)
Message Severity Event Automatic Action by
BMC
Action required by
user
Blade memory fault.
Memory device x+1
(DIMM x+1 Err)
uncorrectable ECC
memory error.
Memory device x
(DIMM x Err)
uncorrectable ECC
memory error.
Processor y (CPU y
Status) internal
error.
Error Checkstop due to memory
fault.
Replace the affected
pair of DIMMs x and
x+1
Memory bank y ,
memory (DIMM x or
x+1 PFA) predictive
failure
Error Predictive failure on memory
channel y for main memory of
IBM PowerXCell 8i.
Replace the affected
pair of DIMMs x and
x+1
Memory device y ,
memory (IOBUF x
PFA) predictive
failure
Error Predictive failure on buffer
memory IOBUF x of the IBM
PowerXCell 8i companion chip.
Replace DIMM
IOBUF x
Other events
Front panel critical
Interrupt
Error NMI reset button on Front
panel pressed
Soft-Reset None. This is a
user-initiated action.
Firmware BIOS
ROM Corruption
detected
Warning Boot WDT Timeout (Firmware
Corrupted)
Reboot & Switch to the
permanent flash side
Reinstall TEMP
image. See
“Recovering the
system firmware
code” on page 64 for
further information.
PCI-X card not
supported
Error DIAGS: Invalid PCI-X Card None No power on, PCI-X
expansion card needs
to be replaced
Recovery messages
106
BladeCenter QS22 Type 0793: Problem Determination and Service Guide