IBM QS22 - BladeCenter - 0793, Service Manual

Page: 67 / 158

Retention clip screws
Ball stud screws
6. Carefully unscrew the retention clip and remove.
7. Position the replacement retention clip over the hole and screw into position,
taking care not to over-tighten as this might damage the system board.
8. If applicable, replace the modular flash drive.
9. Replace the cover and insert the blade server into the BladeCenter unit.
Using the miscellaneous parts kit
The miscellaneous parts kit contains replacement parts and screws to be used if
the original item is damaged. It contains the following items:
Kit, Miscellaneous Parts Quantity Part No
Alignment socket 4 26K6003
Cover for blade server expansion connector 4 28R3024
Pivot point blocks for expansion card support 4 31R2232
Ball stud for expansion card support 4 31R2233
Tray, expansion card support end bracket 2 31R2248
Alignment pin 2 39M6518
Screw, Plastite 4-20x6.35 8 39R9558
Screw, 3.5 x 6 Pan Head, Philips, Planar 6 26K5962
QS22 Planar Light box 2 43W9782
Impedance Air Baffle top, foam 2 43W9966
Impedance Air Baffle DIMM Sides 2 43W9958
Impedance Air Baffle DIMM Sides 2 43W9959
Impedance Air Baffle VRD heat sink, foam 2 43W9967
Impedance Air Baffle VRD heat sink, foam 2 43W9969
Chapter 4. Installing and removing replaceable units
49