IBM QS22 - BladeCenter - 0793, Service Manual

Page: 66 / 158

b. Use your thumb and index finger to lift the battery from the socket.
c. Dispose of the battery as required by local ordinances or regulations.
7. Insert the new battery:
a. Make sure the positive (+) side is facing upwards.
b. Tilt the battery so that you can insert it into the socket, under the battery
clip.
c. Press the battery down into the socket until it clicks into place. Make sure
the battery clip holds the battery securely.
8. Close the blade server cover and insert the blade server into the BladeCenter
unit (see “Closing the blade server cover” on page 52).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
9. Turn on the blade server (see “Turning on the blade server” on page 4).
10. Reset the system date and time through the operating system that you
installed. For additional information, see your operating system documentation.
Replacing the retention clip for the modular flash drive
The retention clip supports the modular flash drive and should be replaced if
damaged.
To remove and replace the retention clip, complete the following steps:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 29.
2. If applicable, shut down the operating system, turn off the blade server, and
remove the blade server from the BladeCenter unit. See “Removing the blade
server from the BladeCenter unit” on page 30.
3. Remove the blade server cover. See “Opening and removing the blade server
cover” on page 31.
4. If applicable, carefully remove the modular flash drive from the retention clip.
5. Using a Philips head screwdriver pierce the label at the red circle corresponding
with the retention clip.
48
BladeCenter QS22 Type 0793: Problem Determination and Service Guide