IBM 4247 - Model 001 B/W Dot-matrix Printer, User Manual

Page: 79 / 454

Rear Pull:
This key is invalid when the printer is in an end-of-forms condition. The last form is
automatically ejected from the printer when an end-of-forms condition is
encountered.
There is no automatic loading for the Rear Pull paper path. When the printer
displays:
Press Stop and manually align the forms on the rear tractor.
Press Load/Eject. Use the Micro
↑
or Micro
↓
to position the forms.
ðð1 END OF FORMS
LOAD FORMS
Push-Pull:
The Push-Pull paper path uses both the front and rear tractors
Ÿ Loading the front tractors
After the forms are loaded under the sensor and onto the tractors at the bottom
of the forms device, press Load/Eject to automatically load the forms to the top
of form position.
Ÿ
Loading the rear tractors
Manually align the forms on the rear tractor. Use the Micro
↑
or Micro
↓
to
position the forms.
Ÿ
Press Form Feed to advance the forms to the top of the next form.
Manual Sheet Feed:
If Automatic Manual Load is set to
Disabled
in the Printer Setup category, the
printer displays:
when a form is inserted into the printer.
Press Load/Eject to advance the form to the first print position.
If Automatic Manual Load is set to
Enabled
in the Printer Setup category, pressing
Load/Eject ejects the form from the printer and remains in the
ready state. See
“Automatic Manual Load” on page 10-14 for more information.
ðð4 PRESS LOAD
Auto Sheet Feed:
Press Load/Eject when the printer is
not ready to eject the current form.
Chapter 2. Understanding the Operator Panel
2-15