IBM 4247 - Model 001 B/W Dot-matrix Printer, User Manual

Page: 243 / 454

|
Ÿ If you are moving a tractor from the Rear Pull or the Rear Push position to
|
the Front Push position, go to step 2a on page 17-7 .
|
Ÿ If you are just installing a tractor in the Front Push position go to step 3 on
|
page 17-8.
a. Grip both sides of the round tractor shaft while operating the tractor release
levers as shown. Lift the tractor out of the printer.
T r a c t o r R e l e a s e L e v e r s
R o u n d T r a c t o r S h a f t
If the tractor was in the Rear Push position, go to step 3 on page 17-8 . If
the tractor was in the Rear Pull position, continue here.
b. Place the tractor face down on a flat surface with the electrical connector
tab on the right side, pointing toward you.
c. Pull the bottom release levers toward you with your finger tips and push the
movable edge of the tractor down toward the flat surface with your thumbs
(1) until the tractor locks in the fully extended position (2).
2 1
Chapter 17. Paper Loading
17-7