![background image](http://html.mh-extra.com/html/hyundai/hl955/hl955_manual_2196435374.webp)
4-31
Observe the fitting direction of the grooved rings and use a suitable fitting needle with
Observe the fitting direction of the grooved rings and use a suitable fitting needle with
rounded edges to fit the new grooved rings. Take care - there is a danger of injury.
rounded edges to fit the new grooved rings. Take care - there is a danger of injury.
Carry out re-fitting of the individual parts into the brake in reverse order. Apply a light coat
Carry out re-fitting of the individual parts into the brake in reverse order. Apply a light coat
of fitting fluid lubricant to the sliding and sealing surfaces of the piston when fitting.
of fitting fluid lubricant to the sliding and sealing surfaces of the piston when fitting.
If necessary, also replace the dust protection cap (10).
The dust protection cap (10) has a vulcanised-in steel ring which is used to press it into the
The dust protection cap (10) has a vulcanised-in steel ring which is used to press it into the
opening in the brake housing (4).
opening in the brake housing (4).
In order to replace this you will need to "lever it out" with a suitable tool and then replace
In order to replace this you will need to "lever it out" with a suitable tool and then replace
with a fitting fixture by pressing it into the housing (4).
with a fitting fixture by pressing it into the housing (4).
Fit the brake onto gearbox in accordance with the fitting instructions. Refer to page 3-171.
Refer to page 3-171.
General instructions
General instructions
Any faults or damage detected on parts not listed here must, of course, be rectified or replaced
by genuine parts.
(3)
(3)
※
※
⑫
※
⑬
A
B
10
1
8
9
7
6
5
4
2
3
7609A4BS26
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...