![background image](http://html.mh-extra.com/html/hyundai/hl955/hl955_manual_2196435334.webp)
3-278
The contact pattern required on the bevel gear set, however, is decisive. If this is not achieved -
see contact pattern check on page 3-285, correct the pinion position with a corresponding shim.
As an alternative, a basic setting of the required pinion position can be made, e.g. when
assembling a new part - as shown below (figure 7577AAXR086
~ 088).
Determine shim for pinion position
Determine shim for pinion position
required to obtain an optimum contact
required to obtain an optimum contact
pattern on the bevel gear set (crown
pattern on the bevel gear set (crown
wheel/pinion) :
wheel/pinion) :
We recommend to reinstall the shim
found during disassembly (e.g. S = 1.20
mm see disassembly instructions, page
3-276, figure 7577AAXR082.) into the
inner bearing hole/pinion bearing.
7577AAXR085
②
※
※
Basic setting of pinion position :
Basic setting of pinion position :
R e a d d i m e n s i o n I = p r o d u c t i o n
dimension/axle drive housing (from axle
center to bearing contact/inner bearing
hole) from the axle drive housing
(position see arrow).
Dimension I e.g . . . . . . . . . . . 182.81
mm
7577AAXR086
Read pinion dimension X (pinion basic
dimension e.g. = 148) from pinion, or
determine it in case of a + or -deviation
from pinion dimension due to production
(value concerned is marked by hand on
the pinion, e.g.+ 0.1).
Pinion dimension X (w or
-deviation value) = 148.0 mm
Pinion dimen. X with indication of + 0.1
deviation = 148.1 mm
Pinion dimen. X with indication of - 0.1
deviation = 147.9 mm
Dimension II (pinion dim. X) e.g
Dimension II (pinion dim. X) e.g . . . .
. . . .
148.00 mm
148.00 mm
Pairing number e.g. 7 - only for version
with bevel gear set - see note figure
7577AAXR083.
7577AAXR087
④
※
③
7
+0.1
148
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...