3-280
Mount heated bearing inner ring until
contact position and adjust after cooling-
down.
7577AAXR091
Set rolling torque of input pinion
Set rolling torque of input pinion
bearing 0.11~0.23 kgf
bearing 0.11~0.23 kgf·m (without shaft
m (without shaft
seal) :
seal) :
Mount spacer ring (s = optional).
We recommend to reinstall the spacer
ring found during disassembly (e.g. s =
8.7 mm).
If the originally installed shim was
replaced (contact pattern/bevel gear set)
- see page 3-278, figure 7577AAXR085,
also install a spacer ring adjusted by the
same correction value.
The required bearing rolling torque of
0.11~0.23kgf
·
m (without shaft seal),
however, is decisive, in case it is not
achieved - see bearing rolling torque
check (figure 7577AAXR094), correct
the bear ing rolling torque with a
correspond- ing shim.
⑨
⑩
※
※
Insert pre-assembled input pinion, mount
heated bearing inner ring until contact is
obtained.
7577AAXR092
⑪
7577AAXR079
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...
