3-242
Reassembly output and brake
Reassembly output and brake
Pull in wheel stud into the output shaft
until contact is obtained.
Wheel stud puller-basic tool
5870 610 001
Insert (M22
×
1.5)
5870 610 002
Special tool may only be used for repair
solution when exchanging individual
wheel studs with mounted output shaft.
When using a new output shaft, mount
the wheel studs with the press.
Wet O-ring of slide ring seal and locating
hole with spirit.
Snap new
new slide ring seal (part 1) into the
output shaft.
Then mount new
new slide ring seal (part 2)
accordingly into the brake housing.
For the installation position of the seal
please also refer to sketch, page 3-244.
The surface of the slide ring seal may not
have any grooves, scratches or other
types of damage.
Take care that the sealing surface is
parallel to the housing face.
The O-rings must be mounted evenly
into the locating hole and must not bulge
out of the hole.
R i s k o f i n j u r y - M e t a l r i n g s h a ve
R i s k o f i n j u r y - M e t a l r i n g s h a ve
extremely sharp edges.
extremely sharp edges.
Wear protective gloves.
Wear protective gloves.
Heat tapered roller bearing and insert it
into the output shaft until contact is
obtained.
(8)
(8)
③
※
①
②
※
7609AAX143
7609AAX144
7609AAX145
7609AAX146
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...
