![background image](http://html.mh-extra.com/html/hyundai/hl955/hl955_manual_2196435299.webp)
3-243
Insert both bearing outer rings (see
arrows) into the brake housing until
contact is obtained.
④
7609AAX147
Insert the premounted brake housing by
means of the lifting device over the
output shaft until contact is obtained.
Before clamping the seal rings (slide ring
seal) to installation dimension, clean the
sliding surfaces and apply an oil film.
We recommend to use a leather cloth
soaked with oil.
Insert back-up rings and grooved rings
into the annular grooves of the brake
housing (see arrows).
Pay attention to the installation position;
please also refer to sketch, page 3-244.
⑤
※
⑥
※
7609AAX149
7609AAX148
Clean the annular groove of the brake
housing with spirit.
Then inser t the guide ring into the
annular groove (see also the following
sketch) and fix it with loctite (type No. :
415) at its extremities (see arrows).
The full circumference of the guide ring
must be in an exact contact position.
Upon installation the orifice of the guide
ring must show upwards (12 o’clock).
⑦
※
※
7609AAX150
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...