HRC NSF250R 2012, Owner'S Manual & Parts List

Page: 200 / 300

6-8
Electrical Servicing
(1) SCREWS
(2) BANK ANGLE SENSOR
Bank Angle Sensor Inspection
Remove the screws and bank angle sensor from the
sensor bracket.
Reinstall the removed parts in the reverse order of
removal.
Connect the bank angle sensor 3P (Natural) connec-
tor.
With the arrow mark on the bank angle sensor fac-
ing up, start the engine.
Incline the bank angle sensor approximately 65
degrees to the left or right, make sure that the
engine stops after few seconds.
If the engine stops, the bank angle sensor is normal.
If the engine does not stop, replace the bank angle
sensor.
With the arrow/UP mark on the bank angle sensor
facing up again, restart the engine.
The engine starts, the bank angle sensor is normal.
(1) ARROW/UP MARK
(2) BANK ANGLE SENSOR
Install the bank angle sensor in the reverse order of
removal.
Install the bank angle sensor with its arrow/UP mark
facing up as shown.
(1)
(2)
(3)
(2)
(1)