HPE ProLiant e910, User And Maintenance Manual

Page: 64 / 182

Serial Command Line Interface Speed
Enables you to change the speed of the serial port for the CLI feature.
The following speeds (in bits per second) are valid:
•
9600 (default)
For Synergy compute modules only: Ensure that this value is set to 9600. If you use another value, you cannot access
the Serial Command Line Interface from the Synergy Console and Composer CLI.
• 19200
•
38400—The iLO configuration options in the UEFI System Utilities do not support this value.
•
57600
• 115200
The serial port configuration must be set to no parity, eight data bits, and one stop bit (N/8/1) for correct operation.
Set this value to match the serial port speed configured in the UEFI System Utilities.
Minimum Password Length
Specifies the minimum number of characters allowed when a user password is set or changed. The character length must
be a value from 0 to 39 characters long. The default value is 8.
Server Name
Enables you to specify the host server name. You can assign this value manually, but it might be overwritten by the host
software when the operating system loads.
• You can enter a server name that is up to 49 bytes.
• To force the browser to refresh and display the new value, save this setting, and then press
F5.
Server FQDN/IP Address
Enables you to specify the server FQDN or IP address. You can assign this value manually, but it might be overwritten by
the host software when the operating system loads.
• You can enter an FQDN or IP address that is up to 255 bytes.
• To force the browser to refresh and display the new value, save this setting, and then press F5.
Authentication Failure Logging
Enables you to configure logging criteria for failed authentications. The following settings are valid:
• Enabled-Every Failure—A failed login log entry is recorded after every failed login attempt.
•
Enabled-Every 2nd Failure—A failed login log entry is recorded after every second failed login attempt.
•
Enabled-Every 3rd Failure (default)—A failed login log entry is recorded after every third failed login attempt.
• Enabled-Every 5th Failure—A failed login log entry is recorded after every fifth failed login attempt.
• Disabled—No failed login log entry is recorded.
Authentication Failure Delay Time
Enables you to configure the duration of the iLO login delay after a failed login attempt. The following values are valid: 2,
5, 10, and 30 seconds.
64 Setting up iLO