HPE ProLiant e910, User And Maintenance Manual

Page: 23 / 182

3. Install the server blade in the chassis.
4. Power up the server blade.
Powering down the server blade
Before powering down the server blade for any upgrade or maintenance procedures, perform a backup of critical data and
programs.
Blades can be powered down individually and as a group of all blades in the chassis. Choose the procedure that fits your need.
To power down, do one of the following:
• Press the Power on button on the server blade momentarily.
This method initiates a controlled shutdown of applications and the OS before the blade enters standby mode.
• Press and hold the Power On/Standby button of the blades installed in the system for 5 seconds, and then release it to
force the server blade to power down.
This method forces the server blade to power down without properly exiting applications and the OS. If an application
stops responding, you can use this method to force a shutdown.
• Use the virtual power button in the Edgeline EL8000 Chassis Manager web interface.
• Use the virtual power button in the blade iLO web interface.
• Enter the
set power off b <slot#>
at the chassis manager CLI. See the HPE Edgeline EL8000 Converged Edge
System Chassis Manager CLI User Guide on the
HPE website for details on CLI commands.
Before proceeding, verify that the server blade is in standby mode by observing that the system power LED is amber. See
Server blade LEDs.
Operations 23