HP T9576G06, Management Manual

Page: 182 / 778

SCF Commands for the SNMP Agent
SNMP Configuration and Management Manual — 424777-006
5- 14
ALTER ENDPOINT Command
NETWORK [\node.]$tcpip-process
identifies the TCP/IP process handling communication between the NonStop agent
process and managers for the receiving and sending of SNMP request/response
messages.
$tcpip-process
is from one to five alphanumeric characters preceded by a
dollar sign ($). The first alphanumeric character must be a letter. The process
name can optionally be qualified with a node name (backslash followed by one to
seven alphanumeric characters, the first of which must be a letter) identifying the
node on which the process is running.
Do not specify a TCPSAM or TPC6SAM process for this attribute if the process
runs on a different node or allow the attribute to default to such a process.
HOSTADDR "ip-address"
specifies the Internet addresses by which the NonStop agent is known to the
network.
Enter
"ip-address"
in standard Internet address dotted-decimal format—
consisting of the ASCII values of four bytes separated by periods—enclosed within
quotation marks. For example: “133.50.85.43”
Considerations: ALTER ENDPOINT
The ENDPOINT object must be in the STOPPED or DEFINED state before you can
alter it.
For ENDPOINT configuration restrictions, see Considerations: ADD ENDPOINT on
page 5-7.
Example: ALTER ENDPOINT
The following example closes, alters the configuration of, and reopens communication
between NonStop agent process $ZSNMP and managers through Internet address
130.50.85.55:
-> ASSUME PROCESS $ZSNMP
-> STOP ENDPOINT #END1
-> ALTER ENDPOINT #END1, HOSTADDR "130.50.85.55"
-> START #END1