HP StorageWorks MSL2024, User'S And Service Manual

Page: 67 / 276

4 Operating the Tape Library
The Tape Library can be operated by the following methods:
• Remote management interface (RMI) — this interface lets you monitor and control the Library from
a web page. You can access most Library functions from the RMI.
• Operator control panel (OCP) — this interface lets you operate the device from the front panel.
• Host backup software — You can perform any functions provided by the backup software.
NOTE:
The device's network settings must be configured and the administrator password set to use the RMI.
Remote management interface (RMI)
Overview
The remote management interface (RMI) lets you monitor and control your device through the World
Wide Web (WWW). The RMI hosts a dedicated, protected Internet site that displays a graphical
representation of your device.
Before using the RMI, you must configure the device network settings and set the administrator password
with the OCP.
(See “ Configuring network settings (Configuration > Configure Network
Settings) ” on page 118 and “ Changing the administrator password (Configuration > Change Admin
Password) ” on page 113.)
To start the RMI, open any HTML browser and enter the IP address of the device in the browser's
address bar.
TIP:
Check the Help screens in the RMI for additional information. The help pages are updated with most
firmware updates and often contain technical details that are not contained in this document. To
access RMI help, click
Help on the right side of the Web page banner, as shown in “ Getting
help ” on page 71.
The following functions are available through the RMI:
• “ Identity ” on page 71
• “ Viewing static device information ” on page 71
• “ Viewing static drive information ” on page 73
• “ Viewing network information ” on page 75
• “ Status ” on page 77
• “ Viewing dynamic device information ” on page 77
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 67