HP StorageWorks MSL2024, User'S And Service Manual

Page: 233 / 276

6. Confirm that the Library recognized the new library controller by checking the System Status on
the front panel, as shown in
Figure 123 .
Figure 123 MSL4048, MSL8048, and MSL8096 system status
.
7. Restore the previous settings by manually entering them in the OCP or RMI.
8. Run HP StorageWorks Library & Tape Tools (L&TT) diagnostic software to verify that the Library
and drives have the latest firmware. L&TT can be downloaded without charge from
http://
www.hp.com/support/TapeTools . If necessary, upgrade the Library firmware through L&TT, the
RMI, or a USB flash drive.
Removing and replacing the base chassis
This process applies to the MSL2024 and MSL4048 only. In this process you will:
• Record configuration settings.
• Remove the tape cartridge from the tape drive.
• Remove the cables, drives, and magazines from the Library.
• Remove the power supply and library controller. (MSL4048 only).
• Remove the Library from the rack or tabletop conversion cover.
• Replace the base chassis.
• Reinstall the Library into the rack or tabletop conversion cover.
• Replace the cables, tape drives, and magazines.
• Replace the power supply and library controller. (MSL4048 only).
• Reconfigure the Library.
WARNING!
The HP StorageWorks MSL2024 Tape Library weighs up to 15.6 kg (34.3 lb) without media and up
to 20.4 kg (44.9 lb) with media (24 cartridges). The MSL4048 Tape Library weighs up to 24.6 kg
(54.1 lb) without media and up to 34.2 kg (75.2 lb) with media (48 cartridges).
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 233